New tall 2pc 2x2 intake by Gear Drive.
12-9-24 We have one in stock, it is polished and very nice, it was used for a mock up. $1100 for the manifold and not, it’s never been run on a engine. Shows some wear but the polishing bill alone is $750. Please contact me for info.
This is a true duel plenum manifold, almost all early tall intake are just a simple divided plenum and really don't work very well. We spent the time to research plenums and how to make the intake work for street or race use. See photo of plenum.
Cast in Minneapolis off tooling we had built over the last year. Our foundry uses very fine sand so the surface finish is better than almost anything out there, standard finish is shot blast and polishing is available.
Allows for use of original ford parts, generator in stock location, fuel pump stand and use the original long fuel pump push rod. Also the short generator from 1933-38 is best on this manifold or aftermarket short powegen is recommended.
Intake comes with the following.
Two gaskets for between the top and base.
Set of 8 stainless steel studs, nuts and thin washers.
____________________________
Intake package options.
Add 2 stainless screen oval air cleaners for $79.99
Add AV8 offset breather tube for $59.99
Add both for $124.99
Questions? 651-485-8075 Thanks Matt
Please Note: Shipping is a wrong for overseas + Canada, right now we have to refund your shipping after we ship. It will come up as $150, after we ship we refund the difference. Sorry about the hassle.
